radio microphone case

IPX6 waterproofMade from UVC-resistant biodegradable TPUDesigned for electronics that require a thin wire to be connected to them at all timesWire pass-through closure keeps them connected and waterproofUsed typically by professionals with specialized electronics FeaturesUse all buttons and switches through the caseAlso protects against dust, dirt and sandLike most of our cases, it will float if you drop it in waterFits wires up to 3.5mmHigh frequency soldered seams to form a super strong bondThis case features our Aquaclip 'TC' system which makes it waterproof to IPX6Temporary submersion is fine, but not continuous submersion Important NotesCases with this clip are for surface use only, but will offer protection against temporary submersion. They are not recommended for prolonged immersionWhen not using the case, leave the closure clip open (wire or tube could possibly cause permanent distortion of the foam, risk of leakage)As long as you follow these instructions, the closure will be waterproof with or without wire/tubeThe maximum thickness of the wire/tube that the closure clip will seal around is 3.5mm